EH1432 Traditional-style Electric stove Poêle Electrique Style Traditionnel Steel construction Flame effect 1.5 kw Turbo fan heater Two heat settings Fabrication en Acier Effet de Flamme Radiateur Soufflant Turbo 1,5kW 2 Réglages de Chaleur Page 1
IMPORTANT Installer and Users please note: These instructions should be read carefully and left with the user of the product for future reference. PRODUCT SAFETY This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Place the EH1432 on a firm flat surface at least 20cm (8") from a wall. Ensure that the air inlets (at the back) and the air outlets (on the front) are not obstructed. Do not direct the hot air output towards curtains or soft furnishings. Do not place on soft surfaces. Do not cover. This symbol shown on the casing of the heater means that the heater should not be covered. Do not use outdoors. Do not use in bathrooms, or in wet or damp locations. Do not place the mains lead beneath a carpet or rug. Do not use the heater in locations where paint, petrol or other flammable substances are present. Do no insert any object into the heater through the grilles. This may damage the heater or result in overheating or electric shock. Page 2
OPERATION Plug the mains lead into a 13 Amp mains socket. If connecting via an extension lead, make sure that the lead is rated at 10 Amps or more, and that it is fully unwound. Switch the unit on at the mains socket. Open the door and use the three switches to select the required operation: For flame effect only, put the ON/OFF switch in the ON position, and the other two switches OFF For low heat, put the ON/OFF switch and the I switch in the ON position, and the other switch OFF For high heat, put all three switches in the ON position. Do not touch the air output grille when the heater is in operation, because it will be hot and may cause burns. Unplug the heater from the mains when not in use. OPERATING COSTS At time of going to press, the average cost of electricity is 0.11 per unit (kilowatt-hour). The amount you are being charged will be shown on your electricity bill. At this cost, the EH1432 will cost 0.16 per hour to run on the high heat setting, or 0.08 per hour on the low heat settingz. On the "flame effect only" setting, the EH1432 will cost 1p per hour to run. PAT TESTING When used in an office environment, this product must be safety-tested yearly by a qualified electrician (PAT Tested) in order to comply with the Electricity at Work Regulations. It is good practice that appliances are regularly PAT tested when used in a domestic environment. Page 3
GENERAL SAFETY REQUIREMENTS Domestic wiring must be tested periodically by a qualified electrician at least once every 10 years or at every change of occupancy. For office and retail premises, and buildings such as village halls, the wiring must be inspected at least once every 5 years. It is recommended that all building be fitted with smoke alarms (it is mandatory for new buildings). MAINTENANCE Before cleaning, turn the heater off, and disconnect from the mains supply. The heater may then be cleaned using a damp cloth with a drop of washing-up liquid to remove any dust or dirt from the case. Do no use stronger detergents or solvents as these may damage the paint finish. Using a dry 1" (25mm) paint-brush, remove any dust from the grilles. If the mains lead is damaged, it must be replaced by the manufacturer or and authorised service centre. If the mains plug needs to be replaced, proceed as follows: Connect the brown wire to the terminal labelled "L". Connect the blue wire to the terminal labelled "N". Connect the green/yellow wire to the terminal labelled with the earth symbol or "E". Make sure that the cord-grip is positioned correctly (over the outer sheath of the cable) and it fully tightened. Page 4
If the lamp providing the flame effect fails, it can be replaced as follows: Disconnect from the mains supply and remove the cover from the back panel labelled "please change the bulb here". Remove the failed lamp, and replace by a new 40 W lamp with a small Edison screw (E14) base. Replace the cover. FAULT-FINDING The EH1432 has a tilt switch which disconnects the power if the heater falls over. If the heater is not operating, restore it to an upright position. The EH1432 has an overheat protection switch, which disconnects the power if the element gets too hot. The usual reason for this is because the air-flow has been obstructed, or the grilles have been blocked. If the heater ceases to operate, leave it for 20 minutes to cool down, then check that the grilles are not being obstructed. Select "Flame effect only" on the switches, and reconnect to the mains supply. If the flame effect operates, then it is safe to select the "low heat" or "high heat" settings. If the flame effect does not operate, or overheat protection switch operates again, contact an authorised service agent for repair. Page 5
TECHNICAL SPECIFICATION Dimensions: 370 415 190 mm Weight: 7 kg Power supply: 230V ~ Power consumption: 1500W Operating current: 6.5 A DISPOSAL AND RECYCLING You must not dispose of this appliance with domestic household waste. Most local authorities have specific collection system for appliances and disposal is free of charge to the end-user. When replacing an existing appliance with a similar new appliance your retailer may take the old appliance for disposal. Page 6
SERVICE WARRANTY Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of twelve months. This Elite product is guaranteed for a further twelve months subject to the enclosed registration card being completed and returned to the address printed on it, or the registration form being completed on-line at www.prem-i-air.com Should this unit be operated under conditions other than those recommended, at voltages other than the voltage indicated on the unit, or any attempts made to service or modify the unit, then the warranty will be rendered void. The product you buy may sometimes differ slightly from illustrations. This warranty is in addition to, and does not affect, your statutory rights. If you have any problems with this product, please call our Help Desk on (0845) 459 4816. Prem-i-Air Appliances Ltd., Lancots Lane, Sutton Oak, St. Helens, Merseyside. WA9 3EX website: www.prem-i-air.com Page 7
IMPORTANT Installateurs et Utilisateurs, veuillez noter: Vous devez lire attentivement cette notice et la conserver précieusement pour une éventuelle future consultation. CONSIGNES DE SECURITE Cet appareil peut être utilisé par des enfants âgés de 8 ans et plus et par des personnes dont les capacités physiques, sensorielles ou mentales sont diminuées ou manquant d'expérience ou de connaissances uniquement sous la surveillance d'un adulte qui leur aura appris à utiliser l'appareil et leur aura expliqué les risques encourus. Les enfants ne doivent pas jouer avec l'appareil. Placez le poêle électrique EH1432 sur une surface plate en respectant un espace de 20cm minimum entre le poêle et le mur. Vérifiez que les entrées d'air (à l'arrière) et les sorties d'air (à l'avant) ne sont pas obstruées. Ne dirigez pas la sortie d'air chaud vers des rideaux ou des tissus d'ameublement. Ne le placez pas sur une surface molle ou instable. Ne le couvrez pas. Un symbole situé sur l'appareil vous rappelle qu'il ne faut jamais le couvrir. N'utilisez pas un programmateur, un temporisateur, une télécommande ou un autre appareil qui allumerait le radiateur automatiquement (car un risque d'incendie existe si le radiateur n'est pas correctement positionné ou s'il est couvert). Ne l'utilisez pas à l'extérieur. Ne pas utiliser dans un véhicule en mouvement ou un bateau. Ne pas utiliser dans alentours immédiats d'une salle de bains, d'une cabine de douche ou d'une piscine. Page 8
Ne pas utiliser dans une salle de bains ou dans une pièce humide. Ne placez pas le cordon d'alimentation sous un tapis ni une carpette. N'utilisez pas le radiateur dans des endroits où de la peinture, de l'essence ou d'autres liquides inflammables sont utilisés ou stockés. N'insérez pas d'objets dans les grilles du radiateur car cela endommagerait le poêle et provoquerait une surchauffe ou un choc électrique. FONCTIONNEMENT Branchez le chauffage dans une prise secteur. Si vous utilisez une rallonge, vérifiez que le câble est calibré à 10 ampères ou plus, et que la rallonge est complètement déroulée. Allumez le radiateur. Ouvrez la porte et utilisez les trois interrupteurs pour choisir le mode de fonctionnement souhaité : Pour un effet de flamme décoratif uniquement, mettez l'interrupteur ON/OFF sur ON et les deux autres interrupteurs sur OFF. Pour une chaleur faible, mettez l'interrupteur ON/OFF et l'interrupteur I sur ON et le troisième interrupteur sur OFF. Pour une chaleur élevée, mettez les trois interrupteurs sur ON. Ne touchez pas la grille de sortie d'air quand le radiateur est en fonctionnement car elle sera chaude et vous pourriez donc vous brûler. Page 9
COUT DE FONCTIONNEMENT Au moment où nous imprimons cette notice, le coût moyen de l'électricité en France est de 0,13 par unité (kilowattheure). A ce prix, le coût moyen de fonctionnement de l'appareil est de 0,20 par heure quand le radiateur est en mode chaleur élevée et 0,10 par heure quand le radiateur est en mode chaleur faible. En mode ''effet décoratif de flamme'', le EH1432 coûtera seulement 0,01 par heure. TEST DE CONFORMITE Quand cet appareil est utilisé en milieu professionnel, il doit être contrôlé tous les ans par un électricien qualifié qui vérifiera la conformité aux normes électriques en vigueur sur les lieux de travail. Quand cet appareil est utilisé à la maison, il est bon le faire contrôler régulièrement. CONSIGNES GENERALES DE SECURITE Le câblage domestique doit être contrôlé périodiquement par un électricien qualifié au moins une fois tous les 10 ans ou à chaque changement d'occupant. En ce qui concerne les bureaux et locaux commerciaux, et les bâtiments comme les salles des fêtes, le câblage doit être contrôlé au moins une fois tous les 5 ans. Il est fortement conseillé d'équiper les bâtiments de détecteurs de fumée (ceci est obligatoire pour les nouveaux bâtiments). ENTRETIEN Eteignez le radiateur avant de le nettoyer. Le radiateur doit être nettoyé en utilisant un chiffon humide avec une goutte de liquide vaisselle pour enlever la Page 10
poussière ou la saleté. N'utilisez pas de détergents forts ni de solvants car cela abîmerait le plastique. A l'aide d'un pinceau sec (25 mm), enlevez la poussière des grilles. Si le cordon d'alimentation est endommagé, il doit être remplacé par un électricien confirmé. Procédez comme suit : Connectez le câble marron sur le bornier libellé ''L''. Connectez le câble bleu sur le bornier libellé ''N''. Connectez le câble vert/jaune sur le bornier libellé ''E'' ou portant le symbole terre. Vérifiez que le serre-câble est positionné correctement (sur la gaine extérieure du câble) et qu'il est bien serré. Si l'ampoule présente des signes de faiblesse, elle peut être remplacée comme suit: Eteignez et débranchez le radiateur. Enlevez le couvercle situé à l'arrière de l'appareil et libellé ''please change the bulb here'' (merci de changer l'ampoule ici). Retirez l'ampoule défectueuse et remplacez-la par une ampoule neuve 40W avec un culot Edison E14 à visser. Remettez le couvercle en place. DEFAUTS DE FONCTIONNEMENT Le EH1432 possède un système de sécurité en cas de basculement si le radiateur tombe. S'il ne fonctionne, remettez-le en position verticale. Le EH1432 possède une protection en cas de surchauffe qui déconnecte le courant si l'appareil devient trop chaud. La raison la plus courante est que les entrées ou sorties d'air sont obstruées et que les grilles sont bloquées. Si le radiateur cesse de fonctionner, laissez-lui 20 minutes pour refroidir puis vérifiez que les grilles ne sont pas obstruées. A l'aide des interrupteurs, sélectionnez ''Flame effect only'' (Effet de flamme uniquement) puis rebranchez l'appareil. Si l'effet flamme fonctionne, vous pouvez sélectionner le mode Page 11
chaleur faible ou chaleur élevée. Si l'effet flamme ne fonctionne pas, ou si le radiateur se met à nouveau en mode protection surchauffe, contactez un technicien pour réparation. CARACTERISTIQUES TECHNIQUES Dimensions : 370 415 190mm Poids : 7 kg Alimentation : 230 V Consommation : 1500 W Courant de Fonctionnement : 6,5 A ELIMINATION ET RECYCLAGE Vous ne devez pas jeter cet appareil avec les ordures ménagères. La plupart des communes possèdent un système de collecte spécifique et gratuit pour ce type d'appareils. Dans le cas contraire, renseignez-vous après de votre mairie. Quand vous remplacez l'appareil existant par un appareil neuf similaire, votre revendeur peut se charger du recyclage de l'ancien appareil. GARANTIE Prem-I-Air garantit le produit contre tout défaut de matériaux et de fabrication pour une période d'un an. Si vous utilisez cet appareil dans des conditions autres que celles recommandées, à des tensions autres que celle indiquée sur l'appareil ou si vous essayez de modifier ou de réparer l'appareil, la garantie est annulée. Le produit que vous achetez peut être légèrement différent de l'illustration. Cette garantie est en sus et n'affecte pas vos droits statutaires. Vous pouvez nous contacter au 01.30.34.48.60. Page 12